@barry
Forum Replies Created
-
Posts
-
You are correct about the audio probe.
You can check the voltages of the transistor but that wouldn’t be my first guess.
This really sounds like a project for the Paramix which will also handle phase inversion.
What is at the end of the two yellow wires? In other words there needs to be a capacitor.
I would reflow the whole project as a normal part of troubleshooting. I can’t find anything wrong component or orientation wise.
Re-measure v3207 after doing all of that and report back.
Hi Daniel, so many questions without photos.
What version of board is this? or at least does it have the Jumper section?
If so what is the placement orientation of the Jumper pair?
Is G2 ground also hooked up?
Voltages for MN3007 are very wrong. Depending on the above questions this is likely the area of focus.
I am not able to replicate an issue. Let me know if anyone else is having an issue.
Let me know if I am missing the issue. see images below.
That is sweet! That is a long time to be in labor.
I see a spot for a 2 Knob Job along the side wall.
Excellent. How do you feel about the tone control rotation? We did them this way because it felt more intuitive while accomplishing the same thing. Some thing that feels like it takes away while turning clockwise did not add up for me.
You can do it either way. It all depends on the builder preference.
I prefer the 3PDT wiring board but not everyone uses them.
Chuck make sure you look at this wiring update.
I had the yellow and purple backwards in the doc.
It should look like this:
