@chuck
Forum Replies Created
-
Posts
-
Thanks Barry. I had Q1 and Q2 reversed. Getting the transistors in the right places made finishing up a piece of cake.
Chuck
Looks like you need to connect G2 at the top left of the board (I know this because I missed it on my own build).
Chuck
For the Vibe version of this board SW1 is just ignored – no need to jump. I did the 45/90 switch on my Vibe and liked it so I’m planning to pull my Dr Phybes apart to do the same mod on the phaser. Make sure both grounds on the Vibe board are wired.
Chuck
Barry, if I hadn’t waited three years between populating the board and boxing it that extra ground wouldn’t have been an issue (and I wouldn’t have this big red palm print on my forehead).
It could be the purpose of my life is to serve as a warning to others.
Chuck
Cybercrow, the box is a Hammond trapezoid from Mouser. It’s a left over from a reboxed build. Had to use JB Weld to fill a couple of inconvenient holes before drilling some more.
Billy, Hot Mess includes my thought process (or lack thereof) and use of a lot of recycled parts. It doesn’t look messy because I’m good at tucking wiring out of sight. I definitely could have added a little more space between the boards – it’s not like I didn’t have much room to play with.
Chuck
Nice looking build Rob. These can be a lot of fun.
Barry, this may be the first on the “new” forum but I’m certain mine from March 2018 wasn’t the first on the “old” forum.
Chuck
