Your Source for DIY Pedal PCBs and NostalgiTone! › GuitarPCB Forum › GuitarPCB Build Support › Fixing PCB to enclosure (answered)

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • January 15, 2019 at 11:23 am #3806
    Anonymous
    Inactive

    Hey Folks,

    Do you have any tips how could I fix the PCB inside the box. I’ve just completed the Bass/Guitar driver and since it has 5 pots and those should be wired  and not soldered to the board I don’t have a fix mounting point so it does not rattle later on.

    Should I use double sided tape or hot glue gun?

    Thanks,
    Gábor

    January 15, 2019 at 12:19 pm #3808
    Cybercow
    Participant

    Personally, I would use double-sided foam tape. The dbl-sided foam will at least release the PCB easier if it ever needs to come out again.

    January 15, 2019 at 12:57 pm #3809
    Anonymous
    Guest

    Barry has some neat board holders in the shop.

    January 15, 2019 at 1:04 pm #3810
    Barry
    Keymaster

    PCB Secure Mounts are available in the SHOP.

    I always say check out our GUIDES PAGES for more information beyond the Build Doc:

    Here is the COMBO GUIDE from the GUIDES PAGES that you could use for ideas.

    January 16, 2019 at 2:37 am #3821
    Anonymous
    Inactive

    Thanks! Will check Musikding for those mounts. (I’m from Hungary so cannot order this from you Barry)

    January 16, 2019 at 12:22 pm #3825
    Barry
    Keymaster

    As I said please read our GUIDES section for alternate methods.

    I believe Klaus was considering carrying them so I would email him at Das Musikding.

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.