Your Source for DIY Pedal PCBs and NostalgiTone! › GuitarPCB Forum › GuitarPCB Build Support › Aion FX Azimuth build

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • December 20, 2022 at 10:22 am #27090
    Anonymous
    Guest

    Hello,

    Built a Aion FX Azimuth Overdrive….which is a take on the Zendrive.

    The pedal has sound thru & sound when engaged….but no gain….turning the gain knob does nothing.

    Any help would be greatly appreciated.  I’m here to learn.

    Thanks.

    December 20, 2022 at 3:27 pm #27092
    Anonymous
    Guest

    You probably have a bad solder joint somewhere on the board.  Try reflowing those connections.

    Otherwise, we can’t provide more help on this forum since your board is not a GUITARPCB product.  Contact AION for more assistance.

    December 20, 2022 at 5:42 pm #27095
    Chuck
    Participant

    Is there a volume increase when the gain pot is turned? If not, recheck that you’ve used the correct value pot and the pot is good as well.  I have an older version of this one and it doesn’t produce gain the way the GuitarPCB Zenith does (that LED in the gain stage does a lot).  My Azimuth does get a bit more hair when the gain is cranked and the volume turned down.

    It would be nice if aion would provide support for their products.

    Chuck

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.