- This topic has 1 reply, 2 voices, and was last updated 4 years ago by
.
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
Hey all. New guy here. I just built a sho nuff v3 today. I had to remove a wire (s6) from the stomp switch to get the device to operate. Not sure why but I assume the wire is unnecessary? Any help?? Also, the 100 k crackle pot has zero range. Absolutely no signal till the end of the sweep, then it’s 100% on. Sounds killer, but I know this isn’t right. I am guessing I need to eliminate a wire there as well. Any help??
thanks In Advance
zedd
Hey Zedd/Zach. Welcome to the forums, fairly new myself.
Something they’ll ask for here is a picture. Can you take shot of the wiring for us? including both the 3PDT and the PCB? thanks!
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.