- This topic has 4 replies, 2 voices, and was last updated 5 years, 2 months ago by
.
-
Posts
-
Since the wiring diagram in the instructions for the MKC is somewhat archaic, I would like to confirm that my plan for wiring the MKC (V3) board is appropriate. The board I received from Mammoth is an updated V3 as seen on the image below with labeled descriptors for the pots instead of “P” for pad. I believe that the actual single Gain pot should be wired to GAIN 1 (trimpot to Gain 2) and that the #1 on the solder eyelets for the pots indicates that is to be wired to Lug #1 on the pot. Please let me know if everything is correct. Thanks.
Archaic is right. If you look at the Master Build Doc list you will notice all Docs with an asterisk in front of them are ones that I have updated thus far and MKC is on the list next. This is one of the few old ones left to do. Everything you have mentioned above is correct and the wiring diagram will work fine.
I would add a Ground wire beside main board +9v and connect it to the a nearby 3PDT wiring board ground pad.
I just noticed that.
The MKC Build Document has been gloriously updated!
- You must be logged in to reply to this topic.