Your Source for DIY Pedal PCBs and NostalgiTone! › GuitarPCB Forum › GuitarPCB Build Support › Ancestral Apparition volume

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • January 16, 2021 at 6:57 pm #16668
    Anonymous
    Inactive

    I built an Ancestral Apparition when they first came out, and used it for a time and then I got an amp that had reverb so I took it off my board. Well I changed amps and this one has no delay so I started using it again but I noticed it is slightly below unity gain. My question is can I change the value of R13 to increase the volume or is there a different resistor that sets the level?

    January 16, 2021 at 9:17 pm #16671
    Cybercow
    Participant

    Just as a shot in the dark . . . .  if raising R13 to 250K doesn’t do it, try raising R10 from 10K Ω to 20K Ω.

    January 17, 2021 at 10:13 am #16684
    Anonymous
    Inactive

    Thanks, I’ll give it a try.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.