- This topic has 3 replies, 3 voices, and was last updated 5 years, 5 months ago by
.
-
Posts
-
Feel like I’m overthinking the wiring for the GuitarPCB 3PDT board and was hoping y’all could check out what I’ve got goin before I solder everything together. All the examples show stereo to mono, not both mono jacks. Any feedback is appreciated!
The current setup for both jacks is:
OK so far. Now add:
Power jack > Main board +9V > 3PDT board +9V
Power Jack ground > Main Board GND > 3PDT board GND
CLR resistor on 3PDT board
common anode bicolor LED or standard LED to 3PDT board
See the Guide Page for more info.
I actually realized I had the jacks wired backwards. I did not understand tip vs. sleeve but got help from some folks on reddit.
https://guitarpcb.com/wp-content/uploads/2020/06/BD_3PDT-WIRING-BOARD.pdf
The bottom left diagram on page 2 is what you needed. You only need a stereo jack off you’re adding a battery snap, which most people do not use these days.
- You must be logged in to reply to this topic.