Your Source for DIY Pedal PCBs and NostalgiTone! › GuitarPCB Forum › GuitarPCB Build Support › SuperLead A and B solder pads?

Tagged: 

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • April 21, 2023 at 11:31 am #28374
    Stitch
    Participant

    I Love the circuits and I have enjoyed building them. I am fairly new to this and I had a question. On the SuperLead O.D. circuit, there are two open solder pads/holes located in the upper left corner beside C3 labeled A and B. What are those for and how can they be used?

     

    Best Regards,

    Stitch

    April 21, 2023 at 4:27 pm #28379
    Playsforfun
    Moderator

    Howdy Stitch. Those lovely A and B pads can be found on many of Barry’s boards. Their main function is to provide us with an easy method of moving the clipping diodes off the main board, and onto a sister mod board, where different options or flavors of diode combinations can be tried by the flick of a switch or the turn of rotary switch. Check out the DPDT board and the Roto-Tone for lots of options and get ready to have fun.

    April 21, 2023 at 7:55 pm #28381
    Stitch
    Participant

    Thanks a million Playsforfun! I figured something of that nature but wasn’t sure. Now, to figure out the next build using these new options!!!

    Again, thank you!!

    Stitch

     

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.