Your Source for DIY Pedal PCBs and NostalgiTone! › GuitarPCB Forum › GuitarPCB Build Support › dlay V3 Warmoth Fanatic not working

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • March 28, 2023 at 3:11 pm #28102
    Anonymous
    Guest

    I have the original dlay and the warp feature works great. Built the dlay V3 and warp not working. The regular echo works fine.

    • switch is connected to the “WF” pad, and solder the other lug to pin 1 of TR1 but nothing happens. The original had 3 wires connected?

     

    March 28, 2023 at 4:30 pm #28107
    Cybercow
    Participant

    Photos of your build please?

    March 29, 2023 at 4:09 pm #28130
    Anonymous
    Guest

    March 29, 2023 at 4:11 pm #28131
    Anonymous
    Guest

    March 29, 2023 at 4:11 pm #28132
    Anonymous
    Guest

    March 30, 2023 at 9:37 pm #28143
    Cybercow
    Participant

    The WF mod should only need two wires to facilitate. The added stomp should be a normally-open, momentary-on type.

    What is the resistor value installed for “R-A”?

    If TR1 is already set to it’s minimum position, the WF mod will have no effect. Have you adjusted TR1 for a correct setting of “near-infinite-repeats when the Repeats pot is set to max?

    March 31, 2023 at 8:54 pm #28152
    Anonymous
    Guest

    R-A IS 8K2

     

    April 1, 2023 at 6:07 pm #28155
    Cybercow
    Participant

    If TR1 is already set to it’s minimum position, the WF mod will have no effect. Have you adjusted TR1 for a correct setting of “near-infinite-repeats when the Repeats pot is set to max?

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.