- This topic has 4 replies, 2 voices, and was last updated 4 years, 2 months ago by
.
-
Posts
-
Looking at the T-Diddy Boost Mod. It wants me to connect Lug 2 of wet pot/ Lug 2 of dry pot
Pad 2 of Wet pot/ Pad 2 of dry pot
Lug 3 of wet pot/ Ground
So my question is for Lug 3 do I connect the pad and the switch?
If you look at the image there are 2 wires soldered to lug 3 of the wet pot. Should the foot switch and the pad 3 of the wet pot both be connected. Or should I left the pad 3 of the wet pot and leave is disconnected?
I haven’t done this mod myself. However, I believe the easiest way to understand it is:
Wire both the WET and DRY pots completely as stated in the Build Doc. THEN, add the DPDT switch and wiring as stated in the T-DIDDY BOOST MOD. You will not remove any of the original wiring. When actuated, the mod will disconnect the DRY signal and turn the WET signal to full ON. I hope this helps.
If I were to do it that way how would that look because the Pad would end up having two wires along with the pot lugs. As of right now this is my understanding of how this should be wired, as you can see the wet pot lug 3 would have no connection. Would that have a negative effect on the pedal. I just don’t see how wiring according to the build docs and the mod would look. It seems like in the picture that I’ve seen of those attempting the mod, it images look to neat to have both the mod and build docs wired though it hard to tell.
- You must be logged in to reply to this topic.