Your Source for DIY Pedal PCBs and NostalgiTone! › GuitarPCB Forum › GuitarPCB Build Support › After Blaster Question

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • January 17, 2022 at 11:29 pm #22559
    Steve
    Moderator

    Looking at the BOM for the After Blaster, there are no dip switches listed for this build. However there are 2 needed for the build. Are the ones listed for the “T-Drive” (https://guitarpcb.com/product/red-dip-switch-2-positions/) the ones I need for the “After Blaster”?

    Thanks, in advance,
    Steve

    January 18, 2022 at 4:40 am #22561
    Barry
    Keymaster

    Hi Steve,

    Actually you do not need two dip switches for the build. You may use a DPDT switch instead for a pedal mounted option. If you do opt for the 2 position switches those are indeed the ones you need and the ones that I carry. See page 2 of the Build Document and the schematic for dip switch. Also see Page 4 of the doc for the DPDT switch.

    I hope that helps.

    January 19, 2022 at 7:56 pm #22595
    Steve
    Moderator

    Actually that does Barry. Decided to go with the toggles instead!
    Thanks!

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.