- This topic has 2 replies, 2 voices, and was last updated 4 years, 6 months ago by
.
Viewing 3 posts - 1 through 3 (of 3 total)
-
Posts
-
if i add the DPDT switch and board as shown here, should i omit the on-board diodes?
Yes I think looking at the schematic you’d leave them out otherwise you’d get the diodes already in the feedback loop plus the ones on the switch position
I don’t think you’d need to jumper anything it looks like pads A and B connect to op amp pins 1 and 2 but continuity check to make sure
super cool. thanks for the confirm, man.
Viewing 3 posts - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.