- This topic has 4 replies, 3 voices, and was last updated 4 years, 12 months ago by
.
Viewing 5 posts - 1 through 5 (of 5 total)
-
Posts
-
Hi folks! I am finally putting the D’lay and Tap Tempo together and need some clarity (don’t we all?)
Tap Tempo S3 is an SPDT ON-OFF-ON, and there are 3 pads for the switch, but looking at the schematic I do not see any routing for that center pad. Rather than wager a guess…
Thanks for reading!
The center pad simply leaves R5 (100K) as the source for pin #12 of the Tap-Tempo chip. It’s basically a just voltage division switch.
Oh yeah! I can see that now, a detour. Thanks Cybercow!
Haha, exactly Barry!
Viewing 5 posts - 1 through 5 (of 5 total)
- You must be logged in to reply to this topic.