- This topic has 3 replies, 2 voices, and was last updated 5 years, 5 months ago by
.
-
Posts
-
I cooked the upper pad of C7 (next do pin 10 on IC2) pretty bad. No more drinking and pedaling for me. I can’t tell where the next spot in the circuit is that I could jumper a wire to. Any help is appreciated. I am sorry I have been posting so much, but I’m a relative newb and I’ve been building a lot.
If the pad underneath is still good, you should be able to solder through there and make a good connection. Otherwise, use your DMM to check continuity on the other C7 pad to determine whether it connects to Pin1 of IC2 or R18. Then look at the schematic, locate C7 and see which connection the bad pad should connect to. That will tell you where you can attach a jumper.
Thanks for the reply, that makes sense.
It works great now. i did this one as a four knobber while the first SWAH I built I did as a three knobber. I guess I am going to have to disassemble that one and do it as a four knobber. I definitely prefer having the added flexibility of having that pot accessible.
- You must be logged in to reply to this topic.