- This topic has 1 reply, 2 voices, and was last updated 5 years, 7 months ago by
.
-
Posts
-
<hr />
Hi there,
I am soldering and the Jacks for the Boogie 57 . And I’m trying to make sure I don’t attached the wrong wires to the wrong sides I’ve looked at the diagrams below and I can’t tell which side is the ground and which wire goes to each. Last time I wired jacks up I did it wrong and ended up pulling up the trace and almost messed it up. Can you look at the jack and assist?
Gabe the best way to check is to put a jack into the socket and follow the solder lugs round, this is a stereo jack but the principle’s the same for mono jacks you can see where the tip, ring or sleeve (ground) connect and follow it round to it’s solder lug connection
The ground lug is always directly connected to the sleeve
Guitarpcb boards have a white square pad with a small T for tip and a ground pad right next to it
- You must be logged in to reply to this topic.