- This topic has 2 replies, 2 voices, and was last updated 6 years ago by
.
-
Posts
-
Hi folks,
Quick question since this will be my firsr GuitarPCB build. I’m reading the documentation on the pedal and the 3PDT pcb, but not sure where the R17 (3k3) needs to go. The doc says to ignore R17 but will it then go on CLR on the 3PDT pcb?
Thank you!
R17 is the LED current limiting resistor Tom
If you’re using a 3PDT pcb you wouldn’t need to put that on the main pcb
You can either have the LED and it’s CLR on the main board or the 3PDT board
So if your LED is going on the 3PDT pcb you’d also put your CLR on that and leave R17 and the LED off the main board it’s just your preference you don’t need both
3K3 is a suggested value, fairly bright if you don’t like your LED bright just increase the resistor value I like mine dull so go with up to 10K
Most folks go with from a 1K8 very bright up to a 4K7
Awesome! Thank you very much. Main pcb done. 😀
- You must be logged in to reply to this topic.