[Playsforfun]

Build doc states that D4 should have a diode or a jumper across the pads the way I’m reading it. I haven’t built the new board version yet.

[Playsforfun]

I think your red wire should go to the 9v pad but it looks like it goes to ground. No power?

[Playsforfun]

Extraordinary! Exceptionally well done all around. Perfect color match on the knobs and label. Nice wiring. Can’t say enough. I’m sure your friend is quite pleased.

[Playsforfun]

Pete was always there for us whether for inspiration, knowledge or just a spot of humor. He will be missed very much by the community that has grown to respect and love him. If any of Pete’s kindness rubbed off on me I feel very lucky to be able to pass it forward. To know him what little I did made a difference in my life. Please visit his extensive galley and glean some inspiration for your next project. He would be honored.

[Playsforfun]

2 thumbs up for the After Blaster. I absolutely love using these in my dirt pedal builds.

[Playsforfun]

Thanks Wilkie1. I too use the original screws if possible. You may only get a few threads to grab depending on manufacturer. To stack boxes I use the cover of the top box as a drill guide. When making your marks for drilling keep in mind the existing screw position and thickness of the walls of the bottom box.  These two pics may show a few ideas. For this combo I decided to fasten the top box on with only 3 screws so that I could hug the corner of the bottom box. Placement of the hole for the wires may need need to be precise depending on what will be in the vicinity. For joining boxes side by side I have used the threaded tubing used to put lamps together. Easily found at the hardware store. Wires can pass through from box to box.

[Playsforfun]

Fine example my friend. Time tested technique profits polarizing perfection.

[Playsforfun]

It’s an eye catcher for sure. Nice work.

[Author]

Posts