@jasonwickersham
Forum Replies Created
-
Posts
-
Just to confirm: you’re getting <strong data-start=”120″ data-end=”140″>no signal at all—even with all three circuits in <strong data-start=”173″ data-end=”183″ data-is-only-node=””>bypass—and when you test them <strong data-start=”207″ data-end=”224″>one at a time (engage one, then return it to bypass before trying the next), there’s still no signal. Is that correct?
Correct. I do hear a slight LFO bleed, but that is it. Think “lead plugged into amplifier without anything on the instrument side.” Switch state does not affect this at all.
Validated switches as well via meter. ringed out properly as a latching 3pdt should.
Hear ya on the taper bits! Just hit send on the order, have 6x mono switched jacks, and 10x c100k inbound.
I finished spotting all other pots earlier this afternoon, and am switching gears to another project..I picked up a huge batch of Other* Pedals boards and faceplates recently.. their Honey Coma (Roland Bee Baa inspired,) is a wildly thick fuzz, with a really cool faceplate. Troubleshooting their “Every’Thang,” ( DOD Vibrothang inspired,) and realized I soldered in the J201 adapter board in ‘backerds… welp, time to fire up ye olde vacuum desoldering wand!!
Woohoo rework 😂PlaysforFun, I am looking into those jacks on Antique Electronics Supply at the moment. Yup, looks like that what i need to make this work, and just a minor wiring modification to the above diagram Barry has up on the site demonstrating daisy chaining of the I/O boards.
Will be a good thing, as I have plans for dual Rats, Muffs, Blues Drivers, and a dual Klon style boost as well.
Welll.. about time to hit order!
Also realized i was out of C100Ks for my Space Modulator board. Tempted to swap in an A100K, but i feel that rate knob would be a bit too touchy, I tend to prefer chorus/flange sloooooow, but with high depth.This looks great!
I recently completed a TSP, and absolutely LOVE it… so much in fact, that I have two additional boards and plan on shoehorning both into a 1590DD, a-‘la KOT, but obviously ‘Screamin Preamps.
Thank you, Barry, I had not been completely through the build guide, but was poking through just the schem.
Just purchase one of these myself, Barry!
Also picking up some assorted items from Pedal Parts, to include a roto tone.. and was curious, would C18 be the appropriate location to install if I wanted to adjust the cap selection for depth control, similar to the Mini-Me mods?
