Your Source for DIY Pedal PCBs and NostalgiTone! › GuitarPCB Forum › Show Off Your Build › Tube Screamer Squared

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • November 19, 2018 at 12:58 pm #3021
    Anonymous
    Inactive

    Here is the “Screaming Duo” – two Ultra Tube Screamers run in series with an Easy Order Switching Board (Toggle) between.

    For the 1st circuit I went with the stock LDO build and the 2nd circuit I went with the RTO version.  For both versions, I used an on/off/on toggle for clipping selection and a toggle at D2 to allow for switching between symmetric and asymmetric clipping when using the silicon clipping option.

    If you like Tube Screamers, you will love the Ultra and if 1 tube screamer is good then 2 has got to be better!

    This one is in GuitarPCB Orange.

    Enjoy.

     

    November 19, 2018 at 1:36 pm #3022
    Anonymous
    Guest

    Now that’s a KILLER combo!  Well done!

    November 19, 2018 at 3:07 pm #3023
    Barry
    Keymaster

    That not only is a killer combo but is a huge step up from the “Tone Of Kings” since they do not offer order switching or as many clipping options as yours does. I would love to be able to demo that.

    November 19, 2018 at 7:33 pm #3027
    Cybercow
    Participant

    Well done. Bravo!

    November 25, 2018 at 12:10 am #3137
    Barry
    Keymaster

    I would like to hear results of using these in tandem and switching order. Especially concerning two different versions of the circuit.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.