Your Source for DIY Pedal PCBs and NostalgiTone! › GuitarPCB Forum › Show Off Your Build › Ancestral apparition

Tagged: 

  • This topic has 9 replies, 5 voices, and was last updated 1 year ago by mybud.
Viewing 10 posts - 1 through 10 (of 10 total)
  • Author
    Posts
  • January 10, 2025 at 1:54 pm #34736
    Michael
    Participant

    Still playing with this method.  It is 4mm laser cut acrylic with the graphics dye sublimated to the far (under) side of the plate.  This graphic got “ghosted” a little but I thought it was appropriate so I didn’t redo it.  Oh, and what a fun pedal!

     

    January 11, 2025 at 1:41 am #34757
    mybud
    Moderator

    Looking good. Nice clean build.

    January 13, 2025 at 11:48 pm #34787
    Steve
    Moderator

    Very nicely done!

     

    April 16, 2025 at 3:03 pm #35997
    Ben Ji
    Participant

    I’m confused with this build document

    Both on the Part list and on the electrical schema appears this component: BTDR-2H
    But i don’t think it is needed anywhere. Can you explain?

    Thanks

    April 16, 2025 at 3:16 pm #35998
    mybud
    Moderator

    That is the digital chip (Belton BTDR-2H) that makes the reverb possible. So it is essential for the circuit to function. Here’s a link to a possible supplier: 

     

    April 16, 2025 at 4:24 pm #36000
    Ben Ji
    Participant

    ok where is it plugged on the board? i cannot see it either on the above example in this thread

    April 16, 2025 at 4:31 pm #36001
    Jeff24
    Participant

    Backside of board.

    April 16, 2025 at 4:31 pm #36002
    Ben Ji
    Participant

    <span style=”-webkit-tap-highlight-color: rgba(0, 0, 0, 0);”>ah! here?</span>

    April 16, 2025 at 4:32 pm #36003
    Ben Ji
    Participant

    excellent thanks

    April 16, 2025 at 4:33 pm #36004
    mybud
    Moderator

    Exactly. Thanks Jeff24.

  • Author
    Posts
Viewing 10 posts - 1 through 10 (of 10 total)
  • You must be logged in to reply to this topic.