Wiring check please

[Anonymous]

This is only the second pedal I have built (the first was a Bearhug Clone in a 1590A). I’m a visual person so I like to doodle out at least what the wiring should be to help avoid mistakes.

Would any of you be willing to check this over please? It’s a Zenith with a Stage3 booster in a 1590BB.

 

 

[wilkie1]

Reverse both wires on the ZEN OUT pad.  The signal must attach to the pad marked with the letter “T”.

I’m not sure if you have the power wire attached to the top lug of the power jack?  The middle lug is for the battery clip.

[Anonymous]

Thanks Wilkie. The power jack vector I used was hard to tell what leg was what. I’ll be sure and check it with a meter to verify.

So just flip-flop the green and purple wires on the Zen out pads?

[wilkie1]

Yep!

[Anonymous]

Thanks much! Can’t wait to give this a go!

[Author]

Posts