DPDT Wiring Board for a circuit with hard clipping (Klone).

[Oscar Lamas]

I want to use the  DPDT Wiring Board for a circuit with hard clipping (Klone). I am lost as fat as being able to make it work. In relation to the wiring board, where shall I place my diodes? as you can tell I have socketed where the Diodes go. I just want to use 2 other diodes with the mod board.

Thanks for the help.

[Barry]

You would need to provide a schematic image and a blank board image.

[Oscar Lamas]

Barry, thanks so much for your reply. Here is what I have.

[Cybercow]

The switch that is already soldered in place appears to be a 3-position toggle. Is it On-On-On or On-Off-On?

It makes a difference because if it’s On-Off-On, there will be no clipping elements engaged in the center position.

If it’s On-On-On, it’ imperative to know which outer lugs are connected to the center lugs and may or may not behave as intended.

In either case, the diode selections would be wired as shown in the image below . . . .

[Oscar Lamas]

It is on off on. It would be just the Op-amp clipping. You are 100% correct.

[Cybercow]

Oscar – with the On-Off-On toggle, you will be good to go with that image I posted.

[Oscar Lamas]

Thanks very much. I truly appreciate your help.

[Author]

Posts