D’Lay v2 + 3PDT v6 – LED question

[Anonymous]

Hello! 🙂
I’m very excited to be finishing up my first GuitarPCB pedal! 🙂 My apologies if this question has been answered before.

I have a version 2 D’LAY pcb and a version 6 GuitarPCB 3PDT wiring board. The LED is going to be installed on the main board, and CLRs for the bi-color LED are already installed on the main pcb (R23 & R24) – What do S4 S5 & S6 connect to on the 3PDT? Furthermore, do I have to jumper the CLR on the 3PDT?

Thanks so much for your help!! 🙂
-Stefanie

[Anonymous]

Based on Stefanie’s situation here, I think something needs to be connected at the S pads, or the stomp won’t be ‘talking’ to the LED at all. Something like the two orange wires at least, although I’m not sure about the pads, as the D’Lay (V2) schematic has pads S4 & S5 listed as LED cathodes, whereas V3 schematic has them listed as S4 & S6.  Cheers, Eric

[Billy]

*edit

Eric’s correct

If using a common anode bi colour LED connect S4 and 6 to the two outer LED pads on the 3PDT pcb

As long as you ground the 3PDT pcb S5 will be fine left unconnected

Apologies! for some reason I was thinking LED connected to 3PDT pcb even though you clearly say it’s on the main pcb

[Anonymous]

Billy, Eric – Thank you so much for your kind, helpful replies and the awesome support! LED works perfectly. 🙂 THANK YOU!! 😀

[Anonymous]

EDIT: Image updated for anyone in a similar situation with V2 Delay PCB + V6 3PDT, and wanting to mount the LED on the main board.  S4 and S6 are the cathode pads for switching colors, as correctly stated above by Billy.

 

[Author]

Posts