Your Source for DIY Pedal PCBs and NostalgiTone! › GuitarPCB Forum › GuitarPCB Build Support › Paramix component confirmation

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • September 17, 2024 at 5:44 am #33421
    HeavyMetalfx
    Participant

    I want to confirm some components on the Paramix before I place an order.

    1.  SW1 SPDT Toggle Switch.  on/on?
    2. SW2 2PDT DPDT Latching Stomp Foot?
    3. Besides the Insert Jacks, the other 4 jacks are standard mono jacks like the Switchcraft 11?
    4. What would be the optimal capacitor for “Guitar Only” for C1-C9?

    Feel free to add any other comments or ideas for this circuit you may have.

    Thanks.

    September 17, 2024 at 10:29 am #33422
    Billy
    Moderator

    Yes to all your questions and I’d personally use 100n for the capacitors

    September 17, 2024 at 12:29 pm #33425
    HeavyMetalfx
    Participant

    Thanks Billy

    September 19, 2024 at 2:30 am #33444
    Big O
    Participant

    The other 4 jacks could be 3 mono and one stereo.  That is 2 mono for the Send and Return, one mono for the Output Jack, and one stereo for the input Jack if you are planning to use a battery snap.  Be careful with the wiring of the Insert In and Insert Out jacks because the ones I used the wiring was slightly different than the diagram in the instructions, although I’m not sure if the ones I used were Switchcraft.

    September 19, 2024 at 4:56 am #33445
    HeavyMetalfx
    Participant

    Thank you Big O

     

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.