@paulm
Forum Replies Created
-
Posts
-
Btw, how did you mount/secure the Pcb? (double sided tape?) I ran cable ties under pots and tied it down that way, bit ugly, but effective.
It’s good to see how someone with some experience chooses to go about it, and compare with mine, yours is def tidier than mine, Lol. Understand the top jack v side jack for pedal board use, at this point I am novice player, and more novice pedal builder, but it’s fun, chose 1590BB enclosure to give myself plenty of room to work with. It’s completed now, and worked first go, so I’m happy about that, sounds great, can get a bit crazy if you want, but also dial back a bit.
I am building this pedal as we speak, my second build, I am new to this and enjoying getting my hands back on a soldering iron. This post also helps with a tech question I was going to ask regarding R24, as this resistor was not listed in parts list, nor supplied with kit (I am in Aust). I have chosen the 4 Knob option, and noticed in schematic that R24 connects pin 1 of pot to Gnd, though shows pin 1 of Bd mounted trim pot is direct to Gnd, a little bit confusing. I have metered the Bd and found both pin 1 of each pot is attached to R24, and other pin of R24 is Gnd, so have bought myself some 33K resistors, and will be fitting this resistor before final assembly.
I have chosen a slightly different layout to what is displayed here, and as I am only beginning on this journey, not really looked into any graphics or decorations, mostly concerned with building functioning pedals at this point, will show my pedal once it is completed.
