@ak7in17
Forum Replies Created
-
Posts
-
Will do but just want let you know I got it working by soldering a wire from what I think is B1 of the order switch to FX1 out.
I checked the continuity of the order switch and there is no continuity from lug B1 and FX1 out. Also i am getting continuity from FX2 output and C1,C2 andC3.
I have done everything that has been suggested, even cleaned the pcb with alcohol .It still does not work. To me it is looking like there is a problem with the pcb.I have been putting pedal kits together for about 15 years now. I know how to do it. I will keep messing around with it. Please keep making suggestions. Thanks Barry and all that are trying to help.
The C13 is a MLCC. Everything works as it should if the order switch is set to have the kicker boosting the mule. When both circuits are in by pass mode (off) and flip the switch to the right putting the mule boosting the kicker there is no clean guitar sound, no sound at all. If I put the kicker on there is no sound. If I put the mule on and start turning the volume than I get a high pitched sound. I also changed the order switch and there was no change. Someone please solve this issue. Thanks.
Both circuits work independently and together only when the kicker is boosting the mule. If the mule is set to boost the kicker then there no sound from the kicker and a high pitched squeal from the mule. Also there is no sound from either circuit in by pass mode.
The power supply is 9v and capable of much higher than 30mA. There were no part substitutions. I have 7 RC4558D and RC4558P chips, tried both but still no change.
