Slight 2 knob job confusion…

[Tim]

<hr />

The diagrams were a little confusing, but is THIS what I’d technically be wiring up?

[Playsforfun]

Hey Tim, For what you need above, follow the wiring diagram on page 6 of the build doc. Remember it shows pads A B and C connecting to the pot location of the original board. The way it connects might seem curious but follow it. It joins pad C to pot tab 1, pad B to pot tab 2 (mid), and pad A to pot tab 3. The pots themselves wire 1 to 1, 2 to 2, and 3 to 3 no problem. Beyond that make sure to ground the boards and provide the needed 9v and a CLR for the led. That should get you there. Let us know how you make out. Of course check with your DMM to prove the connections shown on the schematic make sense. Cheers.

[Author]

Posts