- This topic has 4 replies, 3 voices, and was last updated 1 year, 2 months ago by
.
-
Posts
-
Anyone encountered this problem on the dual Nos Tone boards? For the life of me I cannot figure this out. I’m getting no power to the LED + side of the switching board but have 9v coming out the LED + on the PCBs. If I run a wire directly from the + LED on the main board to the pole position of the LED on the switching board the LED starts functioning correctly. So for some reason power is not being pushed to the switching board. Had the same problem with the Zoso build. There’s no arched solder on anything. I don’t think this is how it’s supposed to work. Barry I need some help/suggestions here lol. Thanks, Brian
The only thing I can think of from your description is from the Build Document under Build Notes #2.
2. Since the Dual PCB offers an additional LED Status location, you can choose your preferred setup. Whichever option you pick, solder a small jumper on the unused LED pads.
If that is not it I am going to have to see pictures with a small description or markup for each photo point.
I agree with Barry on this one. Double check to make sure you jumper the 2 UNUSED LED pads either on the PCB’s or the foot switch board.
Well it would certainly help if I read all the build doc I guess. I completely missed that. Sorry for the blunder. I feel extremely intelligent now lol. Even after building 100+ pedals your assumed experience level can be humbled very quickly. Thanks for pointing that out guys.
- You must be logged in to reply to this topic.