- This topic has 2 replies, 2 voices, and was last updated 2 years, 10 months ago by
.
-
Posts
-
Hello.
I recently just completed my 1st build (OKF) and was successful at it! Very happy indeed!
However, I have a slight issue with it. My LED bulb is slightly lit when the pedal is off. Any assistance please?
Thanks you
-Phil
Post a picture of it Phil
Make sure you don’t have any solder bridges or strands of wire causing a short etc
hey sorry for the late reply! I finally had a chance to get around and getting it fixed! I believe I had some issues with the switch board. Not sure if it was a bad soldering job of the switch itself, or the ground and power wires going to the PCB. But I had a couple extra switch boards and I redid it. Just had to recycle the CLR though. But its working like a champ now!
Also, I failed to mention that I had a weird squeal noise as well whenever I cranked the knob up. But it was corrected with the power board fix.
Appreciate it!
- You must be logged in to reply to this topic.