- This topic has 8 replies, 2 voices, and was last updated 3 years, 9 months ago by
.
-
Posts
-
I would like to make the micro amp with a On, On, On, switch that will have diodes in the negative feedback (Tube Screamer) then to hard clipping in front of the loop, then to no clipping. Can this be done?
I believe I have a switching solution figured out. I wonder if Barry would like to make this a little contest to see who can come up with a correct solution? I recall that TONMANN did this for us a few years back.
This is the best response I have ever seen!! Above all I am thankful that you are willing to take the time to help out a fellow solder sniffer, but a contest!!!, this is becoming very exciting very quickly!
Any updates? I think I may have a way to do it, but my main question is if I put the diodes on a 2pdt switch would I put the diodes in series from one leg of the input to the output of the switch?
what I mean to say is the input leg of the switch to the output.
I’m waiting to see a diagram from users.
Do you want me to send a diagram or pictures? Thanks again
Since we have not had any responses to the challenge, I guess I should just publish the solution I made.
This is great! Thank you again! I was starting this project on the Aeon drive but the Drive is so powerful that it clips the op amp relatively quick. Not a lot of clean head room when the diodes are off. Looking at your switching I can see where I think I am off on my diodes and n series. I will post some pics on that later. I am very grateful for your time and that there is even a place like this to talk shop!
- You must be logged in to reply to this topic.