- This topic has 5 replies, 3 voices, and was last updated 3 years, 3 months ago by
.
-
Posts
-
Hi all, new to this forum.
I am building the Ancestral Apparition and I have one question. On the picture of the circuit board for this Build D2 is shown on the PCB to be oriented stripe down. It also shows this in the photo of the populated board. However, my PCB is shown to have polarity stripe towards the top of the PCB. Was this a change to the circuit board or possibly a misprint on mine? I installed it up as my PCB shows it, but now I wonder if I’m wrong.
Thanks in advance for any help.
Always follow the PCB.
It is probably an error when populating the photo image one part at a time.
I will check into it.
i second Barry’s response. go with the pcb printing. looks like there was a slight change between ’20 and ’22.
So I installed it just like the PCB indicated. I should be ok?
Thanks!
yessir. looking good, man.
Thank you!
- You must be logged in to reply to this topic.