Your Source for DIY Pedal PCBs and NostalgiTone! › GuitarPCB Forum › GuitarPCB Build Support › 2 build questions

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • September 24, 2019 at 10:05 pm #6917
    Anonymous
    Inactive

    Thanks for the site and forum.

    My questions are these:

    On Super 70’s fuzz do I still install diodes 1-4 if I am using pad A and B for a link to switchable diodes? Would it give me an extra choice?

    And separate question 2) on the 3pdt Buffer Bypass board, does the buffer only engage when the other board is off, or does the buffer run all the time including when the other circuit is on? Is it possible to wire the buffer circuit so it is only on when something else is bypassed like a fuzz?

    Thanks for help.

    September 25, 2019 at 12:44 am #6918
    Anonymous
    Guest
    1.  No. D1-D4 would be installed on the external board only.  There would be no extra option by putting them on the main board.
    2.  On that board, the buffer is ON all the time.  Only the other board is bypassed when switched.
    3.  Use a DPDT switch to select between the buffer  and the other effect.  The other effect would not be installed on the 3pdt Buffer Bypass board.
    September 25, 2019 at 1:00 am #6919
    Anonymous
    Inactive

    Thanks!

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.