- This topic has 7 replies, 6 voices, and was last updated 6 years ago by
.
-
Posts
-
Here’s my take on the Killer Bee. Tayda enclosure with a waterslide, 6 coats of clear lacquer and 8 coats of paste wax. I accidentally swapped the drill holes on the footswitch and the LED’s, thus the creative wiring. Using a yellow LED on the stun and red on the kill switches. I haven’t had much time to play with it yet, but seems very touch responsive and would most likely be very good with single coils.
Nicely done! A beautiful enclosure!
Very sharp! Love it. Great job on the wiring. Love the resistor hanging off the 3PDT.
Thanks guys! It’s my third pedal finished. Have a Bearhug compressor in a 1590A and then the Sriracha Fuzz (which kicks ass).
One quick question. I’m assuming the bias for the J113 should be between 5-6v? Closer to 5 for hot pickups and 6 for lower powered ones?
Great looking pedal Shane that wiring is pristine very pro looking
The J113 you can also bias by ear, normal voltage range would be 4.5 to 6v
With hotter pickups I’d probably set it to 4.5v then adjust by ear till you get what you like
- You must be logged in to reply to this topic.