- This topic has 2 replies, 2 voices, and was last updated 5 years, 4 months ago by
.
Viewing 3 posts - 1 through 3 (of 3 total)
-
Posts
-
Hey there,
This might be a stupid question, but the 3pdt wiring diagram shows 2x9v&gnd on the main circuit board. I’m building Dr Rock and SWAH kits,both of which only have 1 of each. So how do I wire this up? Is there another version of that chart?
Cheers
Steve
Alright Steve
There’s never a stupid question mate we all do it differently
The duo of ground and +9v pads on the 3PDT board are there to make it easier for combos etc
What you can do is wire your +9v and grounds straight from the DC jack to the 3PDT board then use the extra one’s to wire power and ground your main pcb
ok I’ll do that. Thanks man!
Viewing 3 posts - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.