Home Forums General DIY Pedal Discussion Wiring check please

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #6133
    Shane
    Participant

    This is only the second pedal I have built (the first was a Bearhug Clone in a 1590A). I’m a visual person so I like to doodle out at least what the wiring should be to help avoid mistakes.

    Would any of you be willing to check this over please? It’s a Zenith with a Stage3 booster in a 1590BB.

     

     

    #6138
    wilkie1
    Moderator

    Reverse both wires on the ZEN OUT pad.  The signal must attach to the pad marked with the letter “T”.

    I’m not sure if you have the power wire attached to the top lug of the power jack?  The middle lug is for the battery clip.

    #6144
    Shane
    Participant

    Thanks Wilkie. The power jack vector I used was hard to tell what leg was what. I’ll be sure and check it with a meter to verify.

    So just flip-flop the green and purple wires on the Zen out pads?

    #6147
    wilkie1
    Moderator

    Yep!

    #6148
    Shane
    Participant

    Thanks much! Can’t wait to give this a go!

Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.