Home Forums GuitarPCB Build Support Paramix build – insert question

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #6128
    Anonymous
    Inactive

    Regarding the optional insert section on the paramix. What happens if you don’t want to use it and just leave it out of the circuit? Do you need to jumper anything?

    #6129
    Cybercow
    Moderator

    Tom – in the build doc it says: “If you don’t wish to install the Insert Jack feature, place a jumper between the upper pad of IO and the upper pad of II.”

    #6130
    Billy
    Moderator

    +1 looking at the schematic you’d need a jumper between the ‘T’ tip pads

    #6134
    Anonymous
    Inactive

    I followed the diagram wiring to a T, but the signal isn’t even passing in bypass… is this supposed to pass true bypass?

    #6135
    wilkie1
    Moderator

    You have a basic wiring error between the jacks and the foot switch board.  You should have signal passing in bypass even without power to the effect board.  Fix this issue first.

    #6188
    Anonymous
    Inactive

    Yep, i knew something was off. I didn’t realize i was using a momentary switch for the footswitch. DOH!

Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.