Im about to finish wiring a one knob fuzz but Im not sure how to do it. I must confess that my skill level is somewhere around ”monkey see, monkey do” and the build document does not show how to wire the footswitch. I dont have a 3pdt wiring board. The big issue is figuring out where the s4 s5 and s6 go.
Build document: https://guitarpcb.com/wp-content/uploads/2018/06/BD_One-Knob-Fuzz.pdf
Any help is greatly appreciated!
All the best
All boards are the same and the s pads are for connecting your led from main board to footswitch. You only need s4 and s5 if using a standard led(not bicolor) The guides page containes many guides for beginners like the one below.