Home Forums GuitarPCB Build Support MKC Ultra Drive Mod Question

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #11981
    Henrik
    Participant

    Hi,

    i’m starting to build my new MKC pedal.

    I want to install the Ultra Drive Mod and ordered a DPDT On/On Switch.

    Couls someone please explain (or show where i can find it in the forum) what ist the best way to install the resistors to the switch an connect the switch to the board?

    I found a picture. Is this the best method to solder the resistors? And then wire the middle 2 pins to the R15 on the board?

     

    Thank you,

    Henrik

    #11983
    Billy
    Moderator

    Yes Henrik

    wire your resistors as shown in your image and then  a wire from each R15 solder pad to the middle common switch lugs

    You can use a DPDT Toggle or footswitch or a 3PDT switch if you want LED indication of whether it’s in ultra gain mode or not

    #12037
    Henrik
    Participant

    Thank you very much,

    Henrik

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.
Close Menu
×
×

Cart