Home Forums Show Off Your Build Killer Bee

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • #12953
    Shane
    Participant

    Here’s my take on the Killer Bee. Tayda enclosure with a waterslide, 6 coats of clear lacquer and 8 coats of paste wax. I accidentally swapped the drill holes on the footswitch and the LED’s, thus the creative wiring. Using a yellow LED on the stun and red on the kill switches. I haven’t had much time to play with it yet, but seems very touch responsive and would most likely be very good with single coils.

     

    #12955
    wilkie1
    Moderator

    Nicely done!  A beautiful enclosure!

    #12958
    Barry
    Keymaster

    That looks amazing. The extra pads came in handy. Thanks for the share.

    #12959
    Bruce R
    Moderator

    Very sharp! Love it. Great job on the wiring. Love the resistor hanging off the 3PDT.

    #12960
    Shane
    Participant

    Thanks guys!  It’s my third pedal finished. Have a Bearhug compressor in a 1590A and then the Sriracha Fuzz (which kicks ass).

    #12962
    Shane
    Participant

    One quick question. I’m assuming the bias for the J113 should be between 5-6v?  Closer to 5 for hot pickups and 6 for lower powered ones?

    #12969
    Billy
    Moderator

    Great looking pedal Shane that wiring is pristine very pro looking

    The J113 you can also bias by ear, normal voltage  range would be 4.5 to 6v

    With hotter pickups I’d probably set it to 4.5v then adjust by ear till you get what you like

     

    #12972
    Cybercow
    Moderator

    – Well done!

Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.
Close Menu
×
×

Cart