Home Forums General DIY Pedal Discussion Industrial Fuzz Power (answered)

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #4952
    Anonymous
    Inactive

    I haven’t built a pedal with PNP transistors until this one, so I’m wondering about the power supply. I use the One Spot for my pedal board, but would I need to get a center positive adapter to run the Industrial Fuzz? And can I run it with other pedals on the board? The build docs show a 9V battery wired standard as well. I appreciate any light shed on this.

    #4955
    Cybercow
    Moderator

    Guitar PCB’s “Industrial Fuzz” does NOT require any special power supply treatment. A positive center power supply is not needed. If you take note of the schematic in the circuit’s build document, you note that Q2 & Q3 are wired in reverse polarity as compared to Q1. Hope this helps.

    #4965
    Anonymous
    Inactive

    Thank you, it does help. Been trying to read the schematics more and understand what does what and why. I keep learning as I go along. I appreciate the response.

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.