Home Forums GuitarPCB Build Support Guitar/Bass Driver question (answered)

This topic contains 3 replies, has 3 voices, and was last updated by  MaxPauwehr 2 months ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #5154

    MaxPauwehr
    Participant

    Hello,

    I just got the Bass driver kit from Musikding and Klaus included your 3pdt wiring board with led.

    I Already used it on the Mastadon and wanted to give it another go. Now I am not quite certain how to do the wiring from the 3pdt to the Mainboard, since the latter only has one 9v pad and as far as I understood the schematics, I would need two.

    How would I connect the power this way?

    Best regards from Germany 🙂

    #5155

    wilkie1
    Moderator

    See the Wiring Examples in the Build Guide section of this forum.  It shows you how to wire the 3PDT switch.

    #5157

    Barry
    Keymaster

    You do not need two. We do that for Combo Build convenience.

    Like Ray said see the Guides. Also if you like two for convenience then the 3PDT Wiring board has three.

    Many ways to do the same thing. It is common power sharing no matter which way.

    #5171

    MaxPauwehr
    Participant

    Ah, now I get it, thanks a lot, really looking forward to getting the Bass Driver done 🙂

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.

Close Menu
×
×

Cart