Home Forums GuitarPCB Build Support Add mix knob to MINI ME Chorus

Tagged: , ,

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #12854
    eliobou
    Participant

    Hello,

    I have a MINI ME Chorus PCB 2020 and I want to add a mix knob. I want to be able to go from 0% to 100% wet. How can I do that ? I was thinking of replacing R12/R13 with a 50k pot (schematic), can it work ?

    #12855
    mybud
    Participant

    Maybe try clipping a pot across the operative points. If you use croc clips, then you don’t have to commit to the PCB until you’ve tested it out. From the look of the schematic, it should work but you might need a nominal value to prevent the pot from cutting out at either end, say 1k or so.

    #12856
    mybud
    Participant

    Hold on a second though, isn’t that what P1 is supposed to do in the first place?

    #12858
    eliobou
    Participant

    The kit is not assembled yet, but I might try that. P1 is the depth of the modulated part of the signal, I want to be able to have a high depth but a low mix so a lot of clean signal

    #12859
    Barry
    Keymaster

    I would use a Buff N Blend.

Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.