I have soldered all except the ground connections on the jacks. I had to change wire colors to redo it and it is still not working. The connections on the jacks were correct. When I reversed them I got no sound at all with the pedal on and off. When I put them back I got a signal with the switch turned off. The ground wires were attached to the sleeve. It may have been hard to see, but I did have those correct. Have tried with the 3DPT PCB and again when I turn it on there is no sound. The green and red wires off to the right go to the 9 volt battery. Sorry for the back and forth – I really appreciate the help, getting super frustrated with myself.