Home Forums GuitarPCB Build Support Micro amp problem (solved) Reply To: Micro amp problem (solved)

#3554
Barry
Keymaster
  • The potis must be used in the Gain pads and you must:
  • solder a fixed 10k resistor between “Volume” pads 1 and 2,
  • and you must place a small jumper between “Volume” pads 2 and 3.

 

 

Then you will still need to make the connection from VB to IC3 in Purple above.

This can be done on the back side of the board best IMHO.

If it helps I think we are very close now.