Home Forums GuitarPCB Build Support Mini Me Chorus build Reply To: Mini Me Chorus build

#13131
Barry
Keymaster

Hi and Welcome,

Switch your Ring and Tip Wires at the Jack. At a glance it looks like these are backwards. See Billy’s Photo of the Jack.

A bit of helpful critique if I may:

You may need to do some board cleanup and reflow as there are a blobs of solder at pads that may be hanging on by a thread. With wire you should strip off a bit of wire and place it through the pad till the protective jacket is flush with the board and then solder the wire to the pad as you would a component lead. You can even move the wire forward while heating to be sure it is flush. Then trim the excess if any. Be sure to use a Fine Conical Tip when soldering wires or components to the board. Also .031 Solder diameter is best.

I hope that helps.