Home Forums GuitarPCB Build Support American Fuzz Pro – Help with first build diagnostic/troubleshooting? Reply To: American Fuzz Pro – Help with first build diagnostic/troubleshooting?

#13003
Billy
Moderator

G zooming in  I could see your main pcb in and outs were correct just couldn’t see where they went to on the 3PDT from what you say that’s correct in T to BI out T to BO other pads to jack grounds

Did you check your IN jack tip wire from the 3PDT goes to the in jack tip solder lug and not the ring

Also need a clearer picture of your DC jack wiring

Make sure you’re putting your in cable to the in jack again very easy to plug your cables into the wrong jacks when you’ve got it upside down etc